AMSI Specializes in:
- Asphalt paving, new installation,
Grading and earth work
- Soil Stabilization [treatments and fabrics]
- Concrete, new installation and repair
Asphalt crack filling
- Seal coatings
- Emulsion seal with black crystal sand
State spec. slurry seal (Cal-Trans 37-2)
- Fuel and oil resistant sealer
- Striping and EDA upgrades
Long-term maintenance programs
Assisting with engineering
- Providing budget estimates
AMSI Provides The Following
~ SUBSURFACE REMOVAL AND
Stable subsoil and base rock prepares a
foundation for a new asphalt surface.
~ ASPHALT REMOVAL AND REPLACEMENT
Deteriorated areas are removed and
replaced with new hot asphalt plant mix.
~ GRINDING OF ASPHALT SURFACE
To ensure proper transition of surfaces,
asphalt edges are ground.
~ PAVING FABRIC
This fiber blanket mends existing
fractures together. It is applied before the new overlay.
~ ASPHALT OVERLAY
One to Four inches of new hot asphalt
plant mix is installed over existing asphalt surface.
~ SHEET OVERLAY
A thin layer of new hot asphalt plant mix
is used to fill in low or eroded areas.
~ CRACK FILLING
A rubber based material is applied in
cracks (either hot or cold).
~ SEAL COATING
Sealant stops erosion and protects the asphalt surface
from harmful elements (sun, water, fuels, oils, etc.).
New layouts or restriping of existing lines.
Along with paving & grading, AMSI also provides a complete
line of concrete services, from a simple driveway remove &
replace, valley gutter, curb work, or a complete building pad.
Home Page | About Us | Our Services | Our Partners | Contact Us
|© Copyright 2007 All Rights
Asphalt Maintenance Systems
1607 Terminal Avenue, San Jose, CA
Toll Free (800) 833-3844
South Bay (408)
East Bay (510) 489-6600